About this replacement
Acer Iconia Tab A1-850 / B1-810 / B1-820 — 3.8V Li-Polymer Replacement Battery (AP14F8K)
This is a 3.8V, 4900mAh lithium-polymer battery for the Acer Iconia Tab A1-850, B1-810, B1-820, and W1-810 series tablets. It replaces OEM part AP14F8K (also listed as KT.0010M.003). If your tablet won't hold a charge or shuts down unexpectedly, this is the direct cell-level replacement.
- A1-850, B1-810, B1-820, W1-810 compatibility: These tablets share the same 3.8V single-cell LiPo architecture, AP14F8K connector pinout, and charge IC handshake — one cell fits all four platforms without modification.
- Bench tested on actual hardware: We ran this cell through charge and discharge cycles on the A1-850 mainboard. The BMS accepted charge negotiation correctly, held cutoff at 4.35V peak, and the protection circuit tripped cleanly at the low-voltage threshold without requiring a manual reset.
- Fuel gauge recalibration after installation: After fitting this cell, run the tablet down to automatic shutoff — do not force-power-off — then charge uninterrupted to 100%. This gives the fuel gauge IC a complete voltage window to map against the new cell and eliminates the erratic percentage readings that appear immediately after a swap.
Acer Iconia Tab shutting down at 15–25% remaining after a battery swap
This happens because the fuel gauge IC — a dedicated chip separate from the main SoC — still holds a charge curve calibrated to the old, degraded cell. Under the combined load of the display, WiFi radio, and background processes, voltage sags faster than the IC predicts, and the tablet interprets the sag as a critically low state. The fix is one full recalibration cycle: discharge to automatic shutoff, then charge to 100% without interruption. After that cycle, the IC maps its curve to the new cell's actual voltage profile and the premature shutdowns stop.
Fast charging not available after fitting the AP14F8K replacement cell
On the Iconia Tab series, the charge controller re-negotiates charge rate at the start of each new session using a protocol tied to the battery's internal resistance reading. A brand-new cell presents a different impedance signature than a worn original, so the controller may default to standard 5V/1A on the first cycle. Run one full uninterrupted charge from near-zero to 100% using the original Acer charger. After that cycle completes, the controller locks in the correct negotiation parameters and fast charge resumes at the expected rate.