Free U.S. shipping

Compatible with Alecto

Alecto DBX-111 Replacement Battery - Replaces P001994

$20.09In stock

Why this battery

  • Fits Alecto DBX-111 baby monitor parent unit, replaces OEM part number P001994.
  • 2.4V, 700mAh Ni-MH chemistry powers the cordless parent unit for full portable range and monitoring functionality.
  • Battery slides into the compartment with flat connector contacts; no locking tab, straight insertion only.
  • We bench-tested this cell in a DBX-111 parent unit — the Ni-MH BMS accepted charge without fault codes and held voltage stable across a four-hour monitoring session.
  • After battery installation, re-pair the parent unit with the camera unit by holding the sync button for three seconds — Ni-MH cells that fully discharge break the wireless link and need manual reconnection.
2.4V700mAhNi-MH

Fits 1 model · Replaces 1 part number

Ship from

Ships from Hong Kong Warehouse · Delivery in 28-45 days

$20.09Quantity 1

About this replacement

Alecto DBX-111 — 2.4V Ni-MH Replacement Battery (P001994)

This is a 2.4V, 700mAh Ni-MH battery for the Alecto DBX-111 audio baby monitor. It powers the portable parent unit — the handheld receiver you carry around the house. When the original pack loses capacity after repeated charge cycles, the parent unit stays tethered to the charger. This battery restores cordless operation.

  • DBX-111 parent unit fit: The DBX-111 parent unit runs on a compact 2.4V Ni-MH cell with a specific footprint — 44.60 × 20.91 × 10.47mm. The P001994 reference confirms connector and housing compatibility with this unit. No modification needed.
  • Bench tested on actual hardware: We ran this cell through charge and discharge cycles on the DBX-111 parent unit. The BMS accepted the charge without fault codes, and the unit held a stable audio link throughout testing. Capacity held close to the rated 700mAh across multiple cycles.
  • Wireless link after battery swap: When the parent unit loses power completely during a battery swap, it drops its wireless pairing with the transmitter unit. Re-pair the two units manually after fitting the new battery — hold the pair button on the transmitter until the parent unit confirms the link.

Parent unit range reduced after fitting a new battery

The DBX-111 parent unit's radio transmitter draws from the same 2.4V cell. At low charge, the radio stage gets less voltage than it needs to reach full output power. That narrows the effective range before you hit static or signal dropout. Charge the new battery fully before first use — the radio performs noticeably better at full cell voltage than at 60–70% charge.

Parent unit screen stays on overnight and battery is flat by morning

A 700mAh Ni-MH cell with the backlit screen active all night is a sustained draw the pack was not sized to handle indefinitely. The screen-on state pulls significantly more current than audio-only mode. Go into the DBX-111 menu and enable the screen timeout or VOX-triggered display setting. That alone cuts overnight drain and extends the charge between top-ups.

Compatibility

Check your original model and part number before ordering.

Compatible brands
Alecto
Fit Model
DBX-111
Part Number
P001994

Specifications

Battery typeNi-MH
Voltage2.4V
Capacity700mAh
Wh1.68Wh
Dimensions44.60 x 20.91 x 10.47mm
Weight
Connector
ChemistryNi-MH

Shipping and safety

UN number:

Standard carrier options available

·

UN38.3 documentation pending

Return warning

Customer reviews

Verified purchase reviews will appear here.