About this replacement
GreenWorks 2000007 Series — 24V Li-ion Replacement Battery (29842)
This is a 24V lithium-ion replacement battery rated at 4000mAh (96Wh), built to the same electrical spec as the original GreenWorks pack it replaces. It fits the 2000007, 2000107, 20362 Chainsaw, 2100007, and over 28 additional GreenWorks 24V cordless garden tools. OEM part numbers covered include 29842, 29852, 29322, G24B2, 29807, and 29837.
- 24V GreenWorks platform fit: These models share a common 24V battery rail, mechanical latch pattern, and BMS handshake protocol. Any pack in this family must match all three — a voltage match alone is not enough for the charger to accept the pack or the tool to release the safety lock.
- Bench tested on actual hardware: We cycled this pack through a GreenWorks 24V trimmer and mower deck under load. The BMS handled motor-start inrush current without tripping and balanced cells correctly across three full charge-discharge cycles.
- Motor inrush conditioning on first use: On first use, run the tool at half load for two cycles before full-torque applications. This allows the BMS to profile the motor's inrush current draw and calibrate its overcurrent protection thresholds before you push the pack hard.
BMS cutoff on GreenWorks mower and chainsaw motor-start inrush
When you pull the trigger on a mower deck or chainsaw, the motor draws a spike of current far above its running load — sometimes 3–5× the steady-state draw. If the BMS overcurrent threshold is set conservatively or the cells are cold, this spike trips the protection circuit and the tool cuts out immediately. This is not a faulty battery — it is the BMS doing its job. A warm pack and a soft-start trigger pull (gradual engagement rather than full pull from rest) keeps the inrush spike below the trip threshold.
Charger blinking red on a 24V GreenWorks pack after storage
A GreenWorks 24V charger blinks red when the incoming pack voltage is below the charger's acceptance threshold — typically around 20V for a 24V pack. Cells sitting unused for several months self-discharge to this level or below, and the charger refuses to begin a full charge cycle. To recover the pack, use a charger with a recovery or conditioning mode, or briefly apply a compatible 24V source at low current to bring each cell above 3.0V. Once the pack reads above the acceptance floor, plug it into the standard GreenWorks charger and the red blink should clear within a few minutes.