About this replacement
Audioline Baby Care V100 — 3.6V Ni-MH Replacement Battery (GP100AAAHC3BMJ)
This is a 3.6V, 900mAh Ni-MH replacement battery for the Audioline Baby Care V100 baby monitor parent unit. It fits the portable handheld unit that parents carry while the camera unit stays at the crib. The OEM part number is GP100AAAHC3BMJ, and it also covers the G10221GC001474 variant of this monitor.
- Baby Care V100 parent unit fit: Both the V100 and G10221GC001474 share the same parent unit housing, connector, and 3.6V three-cell Ni-MH battery configuration. One battery covers both.
- Bench tested on actual hardware: We cycled this battery through charge and discharge on the V100 parent unit. The BMS accepted the cell pack without fault flags, and the unit held a stable display and wireless link throughout the test cycle.
- Re-pair after fitting: After fitting a new battery, re-pair the parent unit with the camera unit. The V100 loses its wireless link when the parent unit drops to zero voltage — it does not automatically reconnect on power-up.
Parent unit not connecting to camera unit after battery swap
When the parent unit fully loses power, the V100 clears its paired device memory. A new battery alone will not restore the wireless link. You need to go through the manual re-pair process — hold the link button on the camera unit, then initiate search on the parent unit. The pair completes when the live feed appears on the parent screen.
Night vision not working after battery replacement
The infrared LEDs on the V100 camera unit draw more current than visible-light operation and require the parent unit to hold a stable voltage above a minimum threshold to maintain the wireless link. If night vision drops out or the feed goes black after a battery swap, the new battery likely has not completed its first full charge. Charge the parent unit to 100% before testing in a dark room. If the issue persists after a full charge, check that the camera unit is within 5 metres during the initial night-vision session.