About this replacement
BLU TouchBook 7.0 Pro / P60W — 3.7V Li-Polymer Replacement Battery (1ICP3/79/115)
This is a 3.7V, 3000mAh (11.1Wh) lithium-polymer battery for the BLU TouchBook 7.0 Pro and P60W tablets. It fits directly into both models, which share the same OEM part number 1ICP3/79/115. Replace it when the original cell degrades, holds little charge, or fails to power the tablet at all.
- TouchBook 7.0 Pro and P60W compatibility: Both tablets use the same battery bay dimensions (114.80 × 79.33 × 3.15 mm), the same 3.7V nominal rail, and the same connector pinout. The OEM part number 1ICP3/79/115 applies to both — no adapter or modification needed.
- Bench tested on actual hardware: We cycled this cell through charge and discharge on the P60W platform. The protection circuit engaged correctly at low-voltage cutoff, and the charge IC accepted the cell without faults on the first cycle.
- Fuel gauge reset after swap: After fitting this battery, run one full discharge to automatic shutoff, then charge uninterrupted to 100%. This forces the tablet's fuel gauge IC to recalibrate against the new cell's actual capacity curve and corrects the inaccurate percentage readings that almost always appear after a battery swap.
TouchBook 7.0 Pro shutting down at 15–25% remaining
This happens because the tablet's display and Wi-Fi radio together create a combined load spike that the voltage curve of a new (or degraded) cell doesn't match what the fuel gauge expects. The gauge reads a voltage drop and interprets it as the cell being nearly empty — triggering shutdown early. Run one complete discharge-to-zero cycle followed by a full uninterrupted charge. After that cycle, confirm the shutdown threshold moves below 10%.
Fast charging not available after battery replacement
The TouchBook 7.0 Pro's charge IC uses a handshake with the charger during the first accepted charge cycle to confirm cell parameters before enabling faster charge rates. On a fresh cell, that handshake may not complete on the very first plug-in. Use the original OEM charger or a USB charger rated at the correct output, let one full charge cycle complete without interruption, and fast charge should negotiate correctly from the second cycle onward.