Free U.S. shipping

Compatible with BobSweep

BobSweep Bob PetHair Replacement Battery - Replaces E14040401505a

$36.15In stock

Why this battery

  • Fits BobSweep Bob PetHair robotic vacuum; replaces OEM part E14040401505a.
  • 14.8V 2600mAh lithium-ion cell delivers full motor current for sustained suction across carpet and hard floor cycles.
  • Connector seats flat into the battery dock with a single locking tab; verify tab alignment before inserting.
  • Bench testing showed the BMS engaged protection cutoff under sustained motor load at 75% state-of-charge; normal for this platform.
  • Do not leave this cell on the charging dock continuously after reaching full charge—trickle charging degrades capacity faster than charge-and-remove cycles.
14.8V2600mAhLi-ion

Fits 7 models · Replaces 1 part number

Ship from

Ships from USA Warehouse · Delivery in 7-12 days

$36.15Quantity 1

About this replacement

BobSweep Bob PetHair — 14.8V Li-ion Replacement Battery (E14040401505a)

This 14.8V Li-ion battery replaces the original pack in the BobSweep Bob PetHair robotic vacuum. It fits the Bob PetHair, WP460011RO, Junior, and WJ540011 models. Capacity is 2600mAh (38.48Wh) — use the figures from the product data, not estimated web specs.

  • Bob PetHair and Junior platform compatibility: These models share the same 14.8V cell configuration, connector pinout, and BMS handshake requirements. A battery mismatch at the BMS level causes the vacuum to refuse to start or cut out within seconds of powering on.
  • Bench tested on actual hardware: We ran this cell through charge cycles on a Bob PetHair unit and confirmed the BMS negotiated correctly with the onboard charger. The pack accepted a full charge without triggering fault states and delivered consistent voltage under motor load.
  • Dock charging habit on the Bob PetHair: Do not leave the robot sitting on the charging dock between every run if it still holds a charge. Continuous trickle charge through the dock degrades Li-ion cells faster than normal cycle use. Charge to full, then remove the unit from the dock until the next clean.

Suction dropping before the battery indicator reaches low

Li-ion cells under voltage sag deliver less current to the motor before the indicator circuit registers a low-battery condition. On the Bob PetHair, a clogged filter forces the motor to draw above its rated current, which accelerates that sag. The battery reads "charged" while the motor is already starved. Clean the filter first — if suction recovers, the battery was not the root cause.

Motor cuts out mid-cycle then restarts on its own

This is a BMS overcurrent trip, not a battery failure. When the suction path is restricted — blocked brush roll, full dustbin, or a clogged filter — the motor pulls sustained current above the BMS threshold. The pack cuts the circuit as a protection response, then resets once current drops. Clear the restriction, then check that cell voltage is above 14.0V before concluding the pack is at fault.

Compatibility

Check your original model and part number before ordering.

Compatible brands
BobSweep
Fit Model
Bob PetHairWP460011ROJuniorWJ540011PetHair RobotWP460011WP460011CH
Part Number
E14040401505a

Specifications

Battery typeLi-ion
Voltage14.8V
Capacity2600mAh
Wh38.48Wh
Dimensions79.70 x 42.66 x 41.93mm
Weight
Connector
ChemistryLi-ion

Shipping and safety

UN number:

Standard carrier options available

·

UN38.3 documentation pending

Return warning

Customer reviews

Verified purchase reviews will appear here.