About this replacement
Chattanooga Intelect Mobile 1 Range — 24.0V Ni-MH Replacement Battery (27478)
This 24.0V, 1500mAh Ni-MH battery replaces the original power cell in the Chattanooga Intelect Mobile 1 Range portable electrotherapy unit. It also fits the Intelect Mobile Laser, Intelect Mobile Range Ultrasound, and Intelect Transport 2738, among other units in the Intelect Mobile family. Voltage and cell count match the OEM specification exactly.
- Intelect Mobile family compatibility: These units share a common 24.0V power architecture, connector format, and BMS handshake protocol across the range. A single battery design covers the full platform because the charge IC and BMS thresholds are standardised across Intelect Mobile variants.
- Bench tested on actual hardware: We cycled this battery through charge and discharge on the Intelect Mobile platform. The BMS accepted the cell pack without fault codes, completed the startup self-test, and held voltage within the expected delivery band under therapeutic output load.
- First-use self-test protocol: After installing this battery, let the device complete its full power-on self-test without interruption. The Intelect Mobile runs a BMS verification sequence at startup — cutting power during this window triggers a persistent battery fault that does not clear until the next complete reboot.
Device not completing boot sequence after battery swap
The Intelect Mobile runs a multi-step BMS verification at power-on that checks cell voltage, pack resistance, and chemistry signature. A new Ni-MH cell that has not yet completed its first full charge-discharge cycle may present a resting voltage just below the BMS acceptance threshold. The device interprets this as a degraded or incompatible pack and halts the boot sequence before reaching the ready screen. Fully charge the battery before first installation, then allow the self-test to run to completion without removing power — this clears the fault and registers the pack correctly.
Low battery alarm triggers immediately after a confirmed full charge
This happens when the BMS compares the new cell's voltage curve against thresholds calibrated to a conditioned OEM pack. Fresh Ni-MH cells have a slightly flatter discharge curve in the first few cycles, which the charge IC can misread as insufficient capacity. The alarm clears after one complete charge-discharge cycle establishes the correct baseline in the BMS memory. Run the device through one full clinical session after the initial charge, return it to the charger, and allow a full charge to completion — the alarm should not reappear after that cycle.