About this replacement
Dell Wireless 360 Speaker — 7.4V Li-ion Replacement Battery (AE715)
This 7.4V, 2460mAh Li-ion battery replaces the AE715 and AE715B cells in the Dell Wireless 360 Bluetooth speaker. It fits the Wireless 360 Speaker directly, restoring wireless audio playback without replacing the unit. Capacity is sourced from the product specification — 18.2Wh.
- Dell Wireless 360 Speaker fit: The AE715 and AE715B share the same 7.4V two-cell Li-ion configuration, connector pinout, and BMS handshake protocol. Both part numbers are accepted by the speaker's charge controller without modification.
- Bench tested on actual hardware: We cycled this battery through full charge and discharge on the Wireless 360 Speaker platform. The BMS engaged cleanly at both the high-voltage cutoff and low-voltage protection threshold, with no false shutdowns under combined amplifier and Bluetooth radio draw.
- Monthly discharge cycle for the Wireless 360: This speaker is often left on a desk and topped off constantly. Let the battery drop below 20% at least once a month before recharging — skipping this causes fuel gauge drift and accelerates capacity fade on the Li-ion cells faster than intermittent full discharge would.
Audio distorting before the battery indicator reaches empty
The Wireless 360 amplifier draws a short current spike at higher volume levels. When the Li-ion cells age or are partially degraded, internal resistance rises and voltage sags under that spike — even if the indicator still shows charge remaining. The audio clips because the amplifier rail drops below its minimum operating voltage before the BMS registers a low-battery event. A fresh cell at full 7.4V nominal restores the headroom the amplifier needs to operate cleanly through the volume range.
Speaker fails to wake from USB charge after sitting unused for weeks
Li-ion cells self-discharge during storage. If the Wireless 360 sits unused long enough, the pack can fall below the USB-C PD minimum acceptance voltage — typically around 2.5V per cell — and the charge controller will not initiate a charge cycle. The BMS interprets the pack as potentially unsafe and blocks input. To recover a deeply discharged pack, hold the power button while connecting USB, which forces a trickle pre-charge on some firmware versions; if that fails, the cells are below recovery threshold and replacement is the correct next step.