About this replacement
DT Research ACC-006-524N — 10.8V Li-ion Replacement Battery
This 10.8V, 2600mAh lithium-ion battery replaces the OEM unit in DT Research tablet computers using part number ACC-006-524N. It restores full power capacity to tablets where the original cell has degraded or failed. Voltage and capacity match the original spec exactly — no modifications needed during installation.
- ACC-006-524N platform fit: DT Research tablets using this part number share a common voltage rail at 10.8V and a three-cell series configuration. The BMS connector pinout and charge termination voltage align directly with the original hardware, so the tablet's charge IC negotiates normally without firmware intervention.
- Bench tested on actual hardware: We ran this battery through charge and discharge cycles on a DT Research tablet platform. The BMS engaged correctly at both low-voltage cutoff and full-charge termination, and the fuel gauge IC picked up the new cell without error flags on the OS side.
- Fuel gauge recalibration after swap: After installing this battery, run it down to automatic shutoff once, then charge uninterrupted to 100%. This single full cycle resets the fuel gauge IC calibration against the new cell and clears the inaccurate percentage readings that commonly appear immediately after a battery swap.
Tablet shutting down at 15–25% remaining after battery replacement
This happens because the fuel gauge IC is still calibrated to the old cell's discharge curve. When the display backlight and Wi-Fi radio draw current simultaneously, voltage sags faster than the gauge predicts, triggering a protective shutdown before the reported percentage reaches zero. The fix is one complete discharge-to-shutoff cycle followed by an uninterrupted charge to 100%. After that cycle, the gauge maps the new cell's actual voltage cliff and the premature shutdowns stop.
Fast charging not available after swapping in the new battery
The tablet's charge IC uses a handshake with the battery BMS to confirm cell condition before allowing higher charge rates. On a freshly installed cell, this handshake sometimes defaults to standard rate until one full accepted charge cycle completes. Plug the tablet into its original charger and let it reach 100% without interruption. After that first complete cycle, the charge IC re-evaluates and fast charge becomes available again — check the charging indicator in the OS to confirm the higher rate is active.