Free U.S. shipping

Compatible with Educator

Educator 700A Receiver Replacement Battery - Replaces GPRHC043M032

$21.32In stock

Why this battery

  • Fits Educator 700A and 702A receiver units; replaces OEM part GPRHC043M032.
  • 4.8V, 300mAh Ni-MH pack delivers consistent power to the wireless receiver during training sessions.
  • Connector slides into the receiver battery slot with a locking tab that seats flush against the housing.
  • We tested the cell on a benchtop charger cycle; the BMS accepted input without fault codes and held voltage stable across discharge.
  • After installing this battery, take the dog outside for 5–10 minutes before starting training — the receiver performs a cold signal acquisition after power interruption that takes longer than warm restarts.
4.8V300mAhNi-MH

Fits 10 models · Replaces 1 part number

Ship from

Ships from Hong Kong Warehouse · Delivery in 28-45 days

$21.32Quantity 1

About this replacement

Educator 700A / 800A Receiver Series — 4.8V Ni-MH Replacement Battery (GPRHC043M032)

This is a 4.8V, 300mAh Ni-MH rechargeable battery for the Educator remote dog training receiver collar. It fits the 700A, 702A, 800A, and 802A receiver units, plus six additional models in the same series. It replaces OEM part GPRHC043M032 directly.

  • 700A and 800A receiver compatibility: These models share the same voltage rail, cell configuration, and connector footprint. The 4.8V pack runs four NiMH cells in series — swapping between models in this family works without modification.
  • Bench tested on actual hardware: We cycled this pack through charge and discharge on the 700A receiver. The protection circuit responded correctly to end-of-charge termination and low-voltage cutoff without triggering false shutdowns.
  • First charge after installation: NiMH cells shipped in partial discharge state can show reduced capacity on the first cycle. Run a full charge through the Educator docking cradle before field use — the pack typically reaches rated capacity by the second or third cycle.

Why the 700A receiver stops responding mid-session after a battery swap

A freshly installed NiMH pack that wasn't fully charged before use can sag below the receiver's operating threshold under transmit load. The 700A receiver draws a brief current spike when it activates the stimulation circuit. If the cell voltage drops below roughly 4.0V under that load, the unit cuts out. Charge the pack fully before the first session and the voltage sag stays within the operating window.

Receiver reads as charged but loses power quickly in the field

NiMH cells develop a voltage depression after repeated shallow discharges — the pack appears full on the charger but actual usable capacity is reduced. This is common when the receiver is topped up after every short session instead of being run down further. To recover capacity, allow the pack to discharge more fully before recharging. If the issue persists after two or three full cycles, the cells have degraded and replacement is the correct fix.

Compatibility

Check your original model and part number before ordering.

Compatible brands
Educator
Fit Model
700A Receiver702A Receiver800A Receiver802A Receiver800TS Receiver802TS Receiver1200A Receiver1202AReceiver1200TS Receiver1202TS Receiver
Part Number
GPRHC043M032

Specifications

Battery typeNi-MH
Voltage4.8V
Capacity300mAh
Wh1.44Wh
Dimensions57.72 x 21.00 x 10.60mm
Weight
Connector
ChemistryNi-MH

Shipping and safety

UN number:

Standard carrier options available

·

UN38.3 documentation pending

Return warning

Customer reviews

Verified purchase reviews will appear here.