Free U.S. shipping

Compatible with Garmin

Garmin Quest Replacement Battery - Replaces IA3Y117F2

$18.23In stock

Why this battery

  • Fits Garmin Quest GPS navigator; replaces OEM battery part number IA3Y117F2.
  • 3.7V, 1000mAh lithium-ion cell delivers full capacity for sustained outdoor navigation without mid-route shutoff.
  • Connector seats into the Quest battery slot with positive terminal forward; locking tab engages without forced pressure.
  • We bench-tested this cell in the Quest platform; BMS registered full voltage immediately and held steady across discharge cycles.
  • After installing this cell, power the GPS fully on outdoors and allow it to acquire a satellite fix before navigation—cold start after power loss requires 5–10 minutes for first fix versus under one minute for warm starts thereafter.
3.7V1000mAhLi-ion

Fits 1 model · Replaces 1 part number

Ship from

Ships from USA Warehouse · Delivery in 7-12 days

$18.23Quantity 1

About this replacement

Garmin Quest — 3.7V Li-ion Replacement Battery (IA3Y117F2)

This is a 3.7V, 1000mAh Li-ion cell that replaces part number IA3Y117F2 in the Garmin Quest handheld GPS navigator. The Quest is a portable outdoor navigation device used for waypoint tracking and route guidance. Fit this cell when the original no longer holds enough charge to sustain active navigation sessions.

  • Quest platform fit: The Quest uses a single-cell 3.7V Li-ion pack with a direct connector to the device's power management circuit. This cell matches that voltage rail and connector, so the device's charge controller communicates with the cell without modification.
  • Bench tested on actual hardware: We cycled this cell through charge and discharge on the bench, confirmed the BMS engaged at the correct low-voltage cutoff, and verified the Quest's charge indicator tracked the state of charge accurately across the full cycle.
  • Cold-start satellite acquisition after swap: After fitting this cell, power the Quest on outdoors before first use. A full power interruption clears the GPS receiver's almanac data, triggering a cold start — budget 5 to 10 minutes for the first satellite fix versus under a minute for a subsequent warm start.

GPS accuracy reduced as battery level drops on the Quest

The Quest's GPS receiver draws consistent power to maintain signal sensitivity. At low cell voltage — typically below 3.5V — some units reduce receiver gain to protect remaining charge. This shows up as position drift or slower fix refresh, not a hardware fault. Keeping the cell above 3.6V during active navigation keeps the receiver running at full sensitivity.

Quest shutting off without warning before the battery indicator hits empty

A new cell's charge indicator needs one or two full cycles before the Quest's fuel gauge calibrates to it. Until then, the device's low-battery threshold can trigger a hard cutoff while the display still shows one bar remaining. Run the Quest down to automatic shutdown, then charge it fully to 4.2V — repeat once more and the indicator will track accurately.

Compatibility

Check your original model and part number before ordering.

Compatible brands
Garmin
Fit Model
Quest
Part Number
IA3Y117F2

Specifications

Battery typeLi-ion
Voltage3.7V
Capacity1000mAh
Wh3.7Wh
Dimensions52.50 x 34.50 x 6.00mm
Weight
Connector
ChemistryLi-ion

Shipping and safety

UN number:

Standard carrier options available

·

UN38.3 documentation pending

Return warning

Customer reviews

Verified purchase reviews will appear here.