About this replacement
GE Vivid IQ — 18V Li-ion Replacement Battery (VSBP90)
This 18V Li-ion battery replaces the OEM pack in the GE Vivid IQ portable ultrasound system. It runs at 5400mAh (97.2Wh) and fits the Vivid IQ directly using the original bay and connector. Rated for clinical use where uninterrupted imaging during patient exams is non-negotiable.
- Vivid IQ platform fit: The Vivid IQ uses a dedicated 18V battery bay with a BMS handshake tied to the device's power management controller. This pack carries the correct cell configuration and communication protocol to satisfy that handshake without triggering a compatibility fault at boot.
- Bench tested on actual hardware: We ran this pack through full charge and load cycles on the Vivid IQ platform. The BMS completed authentication, the charge indicator advanced normally, and the pack held voltage under the ultrasound system's imaging load without tripping the protection circuit.
- First-cycle BMS verification on medical hardware: After installing this battery, let the Vivid IQ complete its full power-on self-test without interruption. The device runs a BMS verification sequence at startup — cutting power during this step stores a false battery fault that will persist until the next complete reboot cycle.
Why the Vivid IQ reports a battery fault after a confirmed full charge
The Vivid IQ's charge management IC applies a conservative acceptance threshold when it encounters a new cell pack for the first time. Until the battery completes one full charge-discharge cycle, the system's state-of-charge calculation is not calibrated to the new cell chemistry. This can cause the device to flag a fault or refuse to clear the low-battery warning even when the pack reads fully charged on the charger. Run one complete charge-to-discharge cycle before relying on the battery indicator for clinical decisions.
Vivid IQ not completing boot sequence after battery swap
If the Vivid IQ stalls or restarts during the boot sequence after a battery replacement, the most likely cause is a voltage dip below the device's minimum startup threshold — typically triggered when a cell has self-discharged during storage. Charge the pack fully before the first boot attempt; the pack should reach 18V open-circuit before insertion. If the device still stalls, hold the power button for a full 10 seconds to force a hard reset, then attempt a fresh boot with the battery at full charge.