Free U.S. shipping

Compatible with Gtech

Gtech Multi MK2 Replacement Battery - Replaces 1301A0002

$44.80In stock

Why this battery

  • Fits Gtech Multi MK2 cordless vacuum and replaces OEM part number 1301A0002.
  • 21.6V lithium-ion with 2500mAh capacity delivers consistent motor voltage under load on carpet and hard floors.
  • Battery slides into the dock with a single locking tab — connector alignment is keyed to prevent reverse insertion.
  • Bench testing showed stable BMS voltage during sustained suction cycles with no early cutoff or thermal throttle.
  • Do not leave this battery on the charging dock permanently — continuous trickle charge degrades lithium-ion capacity faster than charge-and-remove cycles.
21.6V2500mAhLi-ion

Fits 14 models · Replaces 1 part number

Ship from

Ships from Hong Kong Warehouse · Delivery in 28-45 days

$44.80Quantity 1

About this replacement

Gtech Multi MK2 — 21.6V Li-ion Replacement Battery (1301A0002)

This 21.6V 2500mAh Li-ion battery replaces the original pack in the Gtech Multi MK2 and Multi MK2 K9 cordless vacuum cleaners. It also fits the ATF011 and Power Floor MK1 platforms. When the original cell loses hold, suction drops early — this pack restores full motor voltage across the cleaning cycle.

  • Multi MK2 and K9 platform fit: These models run the same 21.6V architecture with a shared connector footprint and BMS handshake. The K9 variant draws slightly harder through pet hair attachments, but the voltage rail and charge protocol are identical across the range.
  • Bench tested on actual hardware: We ran the pack through full charge and discharge cycles on the Multi MK2 dock. The BMS handled cutoff cleanly at low voltage and accepted the charger handshake without fault codes or charge refusal on the first connection.
  • Dock charging discipline for the Multi MK2: Do not leave this vacuum sitting on the dock continuously. Gtech cordless vacuums develop capacity fade noticeably faster under constant trickle charge. Charge to full, remove from the dock, and return it only when depleted.

Why the Multi MK2 loses suction before the battery indicator hits low

The battery indicator on the Multi MK2 reads cell voltage, not available capacity. As a Li-ion pack ages, internal resistance climbs. Under motor load, voltage sags below what the BMS needs to sustain full motor speed — even while the indicator still shows charge remaining. A new pack with low internal resistance holds voltage steady under load, so the motor gets consistent power from the first pass to the last.

Motor cuts out mid-clean then recovers after a few seconds

This is a BMS overcurrent trip, not a dead battery. When airflow is restricted — blocked filter, packed brush roll, or a sealed nozzle — the motor works harder and draws current above the BMS cutoff threshold. The BMS shuts down to protect the cells, then resets once current drops. Clean or replace the filter first. If the cut-out stops, the battery was not the problem. If it continues with a clear filter, check the brush roll for hair wrap before drawing any conclusion about the cell.

Compatibility

Check your original model and part number before ordering.

Compatible brands
Gtech
Fit Model
Multi MK2Multi MK2 K9ATF011Power Floor MK1Power Floor MK1 K9ATF024ATF035ATF29ATF027ATF040ATF036ATF037ATF038ATF039
Part Number
1301A0002

Specifications

Battery typeLi-ion
Voltage21.6V
Capacity2500mAh
Wh54Wh
Dimensions142.34 x 83.80 x 51.76mm
Weight
Connector
ChemistryLi-ion

Shipping and safety

UN number:

Standard carrier options available

·

UN38.3 documentation pending

Return warning

Customer reviews

Verified purchase reviews will appear here.