About this replacement
Hisense X9T / X5T Series — 3.8V Li-Polymer Replacement Battery (LI38250)
This is a 3.8V, 2500mAh Li-Polymer replacement cell for the Hisense X9T, X5T, and HS-X5T smartphones. It matches the OEM part number LI38250 and slots into the same battery bay as the factory cell. Use it when the original cell no longer holds a charge or causes unexpected shutdowns.
- X9T, X5T, and HS-X5T compatibility: All three models share the same battery bay dimensions, connector pinout, and BMS handshake protocol. The LI38250 cell fits each without modification — same 73.04 × 53.86 × 4.23 mm footprint and matching voltage rail.
- Bench tested on actual hardware: We ran this cell through charge and discharge cycles on the X9T platform. The BMS accepted the cell without a protection trip, and the charge IC reached termination voltage cleanly at 4.2V.
- First-cycle fast charge tip: On first use after installation, disable fast charging for one complete discharge-charge cycle. This lets the fuel gauge IC recalibrate against the new cell's discharge curve before high-current charging pushes current into an uncalibrated cell.
Sudden shutdown at 20–30% on the Hisense X9T after a cell swap
The X9T's fuel gauge IC holds a discharge curve learned from the old cell. When a new cell goes in, the IC still references that old curve — so the voltage it reads at 25% on the old cell may correspond to a genuine 10% or less on the new one. Under modem or screen load, the new cell hits its low-voltage cutoff before the OS expects it, and the phone cuts power. One full discharge-charge cycle from 100% down to automatic shutdown, then back to 100%, rewrites the fuel gauge's reference curve to match the new cell.
Battery percentage jumping erratically after replacement
Erratic percentage readings — jumping from 60% to 40% in seconds, or stalling at one number for an hour — are a coulomb counter recalibration issue, not a cell defect. The coulomb counter in the X9T's fuel gauge IC tracks charge in and out, but its reference anchors are still tied to the old cell's capacity. Run two full uninterrupted charge cycles without removing the phone from the charger mid-cycle. After the second cycle, the IC resets its anchor points to the new cell's actual capacity, and percentage tracking stabilises.