About this replacement
HP Stream 11 Series — 11.4V Li-ion Replacement Battery (ME03XL)
This is an 11.4V Li-ion battery rated at 3100mAh (35.34Wh), built to replace the original ME03XL cell in HP Stream 11 notebooks. It fits the Stream 11-D001DX, D010CA, D010NR, D010WM, and over 240 additional Stream 11 variants sharing the same battery bay and connector. Slot it in when the original cell can no longer hold charge through a normal work session.
- Stream 11 series compatibility: These models share the same 11.4V three-cell architecture, identical battery connector pinout, and the same BMS handshake protocol — which is why one cell covers the full range without modification.
- Bench tested on actual hardware: We ran this cell on a Stream 11 unit and confirmed the BMS negotiated charge correctly, hit full cutoff at 11.4V rated ceiling, and passed all four-pin communication checks without error flags.
- Post-install calibration on Stream 11: After fitting, run the laptop on battery until it drops to hibernate cutoff — do not plug in mid-cycle. Then charge uninterrupted to 100%. This forces the BIOS battery learn cycle to reset against the new cell and clears the false health warning that appears after every cell swap on this platform.
Why the Stream 11 reports poor battery health immediately after a cell swap
The Stream 11 BIOS stores charge history and wear data from the previous cell in EEPROM. When a new cell goes in, that old data conflicts with what the fuel gauge IC is actually reading. Windows will show "Consider replacing your battery" or a low health percentage even though the cell is brand new. Running one complete discharge-to-hibernate followed by a full uninterrupted charge resets the learn cycle and writes fresh baseline data to EEPROM. After two to three calibration cycles, the reported health figure will reflect the actual new cell state.
Stream 11 shutting down unexpectedly at 20–30% remaining
This happens because the fuel gauge IC is still calibrated against the old cell's voltage curve. At full CPU and display load, the new cell's actual voltage drops faster than the gauge predicts, and the system hits the low-voltage safety cutoff before the displayed percentage reaches zero. It is not a faulty battery — it is a calibration gap. Run two full discharge-to-100% charge cycles without interruption. By the third cycle, the gauge IC maps the new cell's voltage curve accurately and the premature shutdowns stop.