About this replacement
Huawei Enjoy 20 Pro / Z 5G — 3.85V Li-Polymer Replacement Battery (HB426388EEW)
This is a 3.85V, 3900mAh (15.02Wh) Li-Polymer battery carrying OEM part number HB426388EEW. It fits the Huawei Enjoy 20 Pro, Enjoy 20 Pro 5G, Enjoy Z 5G, and the DVC-AN00 variant. It replaces cells that have lost capacity, fail to hold charge through a full day, or trigger sudden shutdowns under load.
- Enjoy 20 Pro and Z 5G compatibility: Both the 4G and 5G variants of this lineup use the same battery bay dimensions, connector pinout, and BMS handshake. The HB426388EEW cell is the common part across all four variants — swapping between models does not change fitment.
- Bench tested on actual hardware: We ran this cell through a full charge-discharge cycle on the DVC-AN00 board. The BMS accepted the cell without rejecting the charge IC handshake, voltage held steady across the modem-active load, and the fuel gauge IC picked up the new discharge curve after one complete cycle.
- First-cycle fuel gauge calibration: On first use after installation, disable fast charging for one complete discharge-charge cycle. The fuel gauge IC is still calibrated to the old cell's discharge curve. Running one slow cycle lets the coulomb counter re-anchor to the new cell before high-current charging begins.
Sudden shutdown at 20–30% on the replacement cell
This happens because the fuel gauge IC carries the old cell's voltage-to-capacity curve into the swap. When the new cell hits a voltage point the old curve mapped to 20–30%, the phone treats it as critically low and cuts out — even if actual charge remains. The modem or screen pulls a short current spike, the reported voltage crosses the shutdown threshold, and the OS kills power immediately. One full slow discharge to 0% followed by an uninterrupted charge to 100% resets the coulomb counter. After that cycle, the gauge tracks the new cell accurately and shutdowns at 20–30% stop.
USB-PD fast charge not activating on the first cycle after installation
On the first charge cycle, the BMS in a fresh cell may hold the charge IC in trickle mode while it verifies cell impedance. The phone's fast charge protocol — whether Huawei SuperCharge or USB-PD — only negotiates higher voltage after the BMS signals the cell is within its normal impedance window. Plugging into a fast charger and seeing only standard 5V output is normal on cycle one. Let the first charge complete fully on any charger; fast charging activates automatically from cycle two once the BMS clears the impedance check.