About this replacement
Huawei Mate 30 / Honor View 30 — 3.85V Li-Polymer Replacement Battery (HB486586ECW)
This is a 3.85V, 4100mAh (15.79Wh) Li-Polymer cell for the Huawei Mate 30, Honor View 30, Honor V30, and TAS-L09, among other compatible variants. It replaces OEM part HB486586ECW when the original cell can no longer hold charge or causes unexpected shutdowns. The cell matches the physical dimensions of the factory pack at 83.60 x 63.25 x 4.50mm.
- Mate 30 and Honor V30 series compatibility: These models share the HB486586ECW form factor, voltage rail, and BMS handshake requirements. The connector pinout and cell dimensions are identical across the Mate 30, Honor View 30, and TAS-L09 variants, so one cell fits the full range without modification.
- Bench tested on actual hardware: We ran this cell through charge and discharge cycles on the Mate 30 platform. The BMS accepted the cell, reported state-of-charge correctly after one full cycle, and fast-charge protocols re-engaged without fault codes on subsequent charges.
- First-cycle fuel gauge recalibration: On first use after installation, disable fast charging and run one complete discharge-charge cycle at standard rate. This lets the fuel gauge IC map the new cell's discharge curve before high-current fast charging pushes current into an uncalibrated cell — skipping this step causes erratic percentage readings in the first few days.
Sudden shutdown at 20–30% on the Mate 30 after a cell swap
This happens because the fuel gauge IC is still using the discharge curve it learned from the degraded original cell. When the modem or display pulls a high current spike, the new cell's voltage drops briefly below the system's cutoff threshold — even though the reported percentage looks safe. The phone interprets this as a critical low-voltage condition and shuts down to protect the SoC. One full discharge to around 3.0V followed by an uninterrupted charge to 100% forces the coulomb counter to resync with the actual cell capacity.
USB-PD or Huawei SuperCharge not working on the first cycle after replacement
After a cell swap, the charge IC on the Mate 30 performs an impedance check before allowing fast-charge protocols to engage. A new cell with higher impedance than the worn original can cause this check to fail on the first cycle, so the phone falls back to standard 5V charging. This is not a fault — it resolves on its own once the cell has completed one full charge cycle and the BMS has logged baseline impedance data. If fast charging still does not engage after two full cycles, check that the USB-C cable is rated for the required current and verify the charger outputs at least 10V/4A for SuperCharge.