About this replacement
Huawei P10 Plus — 3.82V Li-Polymer Replacement Battery (HB386589CW)
This is a 3.82V, 3750mAh Li-Polymer replacement battery for the Huawei P10 Plus smartphone. It fits the standard P10 Plus, P10 Plus Premium Edition, P10 Plus Premium Edition Dual, and VKY-AL00 variants. Install it when the original cell has degraded to the point of unexpected shutdowns, erratic percentages, or reduced screen-on time.
- P10 Plus and Premium Edition variants: All listed models share the same battery bay dimensions, connector pinout, and BMS handshake protocol. The HB386589CW cell works across VKY-AL00, WS-AL00, and other regional variants because Huawei standardised the power rail at 3.82V across the P10 Plus line regardless of storage tier.
- Bench tested on actual hardware: We ran this cell through full charge and discharge cycles on P10 Plus hardware. The BMS accepted the cell without throwing charge faults, and the fuel gauge IC completed its initial calibration pass cleanly across a full 0–100% cycle.
- First-cycle fast charge protocol: After fitting this cell, disable Huawei's SuperCharge for the first complete discharge-charge cycle. The fuel gauge IC needs to map the new cell's discharge curve before the charge controller pushes high current. Run one full cycle on standard 5V/2A charging, then re-enable SuperCharge.
Sudden shutdown at 20–30% on the P10 Plus after a cell swap
The P10 Plus uses a coulomb-counting fuel gauge IC that was calibrated to the original cell's internal resistance profile. A new cell has lower impedance, so the IC's voltage cliff model is off — it triggers a protective shutdown before the cell is actually empty. This is not a defective battery. The fix is one full uninterrupted discharge down to automatic shutdown, followed by a full charge to 100% without interruption. After that cycle, the fuel gauge IC rewrites its reference curve to the new cell and the 20–30% cutoff stops occurring.
SuperCharge stops negotiating after replacement — phone charges at 5W only
Huawei's SuperCharge protocol requires the charge IC to confirm cell impedance is within a safe window before stepping up current. On a brand-new cell, impedance reads slightly high on the first cycle, and the charge IC defaults to standard 5V charging as a precaution. This is expected behaviour — not a fault with the charger or the battery. Complete one full standard charge cycle and SuperCharge negotiation resumes normally on subsequent connections to the original SuperCharge adapter.