About this replacement
Lenovo Lemon 3 / K32C36 — 3.8V Li-Polymer Replacement Battery (BL259)
This is a 3.8V, 2700mAh lithium-polymer replacement battery for the Lenovo Lemon 3, Lemon 3 Dual SIM TD-LTE, and K32C36 smartphones. It uses OEM part number BL259 and fits the standard battery bay without modification. Swap it in when the original cell can no longer hold a charge through a normal day of use.
- Lemon 3 / K32C36 platform fit: These three models share the same physical footprint, connector pinout, and BMS handshake protocol, which is why a single BL259 cell covers all of them. Voltage tolerance on the charge IC is identical across the range.
- Bench tested on actual hardware: We cycled this cell through charge and discharge on the K32C36 board. The BMS accepted the cell without error flags, and the charge IC ramped current correctly from trickle to CC/CV without thermal cutoff.
- Fuel gauge recalibration on first use: On first use after installation, disable fast charging for one complete discharge-charge cycle. This lets the fuel gauge IC map its coulomb counter against the new cell's actual discharge curve before high-current charging begins on an uncalibrated reference.
Sudden shutdown at 20–30% on the BL259 replacement cell
This happens when the fuel gauge IC still references the old cell's discharge curve. The new cell hits a voltage cliff under modem or display load — actual cell voltage drops below the SoC cutoff threshold even though the percentage shown is still in the 20–30% range. The phone interprets that voltage drop as a fault and shuts down to protect the board. One full discharge-charge cycle without fast charging resets the coulomb counter and corrects the mismatch.
Phone won't power on after the BL259 sat in storage
Lithium-polymer cells self-discharge in storage. If the cell voltage drops below approximately 2.5V per cell, the BMS enters lockout mode and blocks charging to prevent damage. The phone will appear completely dead — no charge indicator, no vibration on cable connection. Connect to a wall adapter rated at 5V/1A and leave it for 20–30 minutes before attempting to power on; the charge IC runs a trickle pre-charge below 3.0V to recover the cell before entering normal CC/CV charging.