About this replacement
Logitech UE MegaBoom — 7.4V Li-ion Replacement Battery (533-000116)
This 7.4V, 2600mAh Li-ion battery fits the Logitech UE MegaBoom portable Bluetooth speaker (model S-00147). It replaces OEM part numbers 533-000116 and 533-000138. When the original cell degrades and the speaker no longer holds charge through a session, this swap restores the pack to factory capacity.
- UE MegaBoom and S-00147 fit: Both model references use the same 7.4V cell configuration, connector pinout, and BMS handshake. The replacement pack communicates capacity data back to the speaker's onboard fuel gauge without requiring any firmware workaround.
- Bench tested on actual hardware: We ran this pack through charge and discharge cycles on the MegaBoom platform. The BMS responded correctly to charge termination, held voltage within spec under sustained audio load, and did not trigger overcurrent cutoff during amplifier peaks.
- Monthly discharge cycle for MegaBoom users: If the speaker sits on a desk and gets topped off before it drops below 50%, the fuel gauge drifts over time. Run the speaker down below 20% at least once a month before recharging — this keeps the cell calibration accurate and slows capacity fade on the Li-ion cells.
Audio distorting before the battery indicator reaches empty
As a Li-ion cell ages, its internal resistance rises. Under load — particularly at high volume — the cell voltage sags faster than the fuel gauge can track. The amplifier then clips because it's receiving less voltage than it needs, producing distortion while the LED indicator still shows charge remaining. A fresh 7.4V pack with lower internal resistance eliminates the sag, and the distortion disappears at the same volume levels. If distortion returns on a new pack, check that the speaker firmware is current, as older firmware versions had known fuel gauge calibration bugs.
Speaker won't wake from USB after sitting unused for weeks
Li-ion cells self-discharge at roughly 2–3% per month. If the MegaBoom sits unused long enough, the cell voltage drops below the USB charging controller's minimum acceptance threshold — typically around 2.5V per cell — and the charger won't initiate a charge cycle. The BMS reads the cell as unsafe and blocks the connection. To recover the pack, connect it to a charger that supports a pre-charge or trickle mode, or use a bench power supply set to 5V at a current-limited 100mA to nudge the cell voltage above the acceptance floor before switching to a standard charger.