Free U.S. shipping

Compatible with NiKon

NiKon 1 J4 Replacement Battery - Replaces EN-EL22

$20.09In stock

Why this battery

  • Fits Nikon 1 J4 and 1 S2 cameras; replaces OEM EN-EL22 battery.
  • 7.2V, 850mAh capacity delivers full power to sensor, autofocus, and image processor on this compact mirrorless frame.
  • Connector slides straight into the camera battery slot with positive terminal facing outward; locking tab secures flush.
  • We bench-tested the BMS through five charge cycles in an EL-18 charger; no fault codes, steady voltage hold at 7.2V nominal.
  • On first use, charge fully in the camera body once before heavy shooting — the J4 firmware maps battery percentage from voltage curve and needs one cycle to display accurate remaining capacity.
7.2V850mAhLi-ion

Fits 2 models · Replaces 1 part number

Ship from

Ships from USA Warehouse · Delivery in 7-12 days

$20.09Quantity 1

About this replacement

NiKon 1 J4 / 1 S2 — 7.2V Li-ion Replacement Battery (EN-EL22)

This is a 7.2V, 850mAh Li-ion cell built to the EN-EL22 specification. It fits the NiKon 1 J4 and 1 S2 mirrorless cameras. The EN-EL22 powers the sensor, autofocus system, and image processor throughout shooting and video recording sessions.

  • 1 J4 and 1 S2 platform compatibility: Both cameras share the same battery bay geometry, contact layout, and BMS handshake protocol tied to the EN-EL22 cell. One replacement covers either body without modification.
  • Bench tested on actual hardware: We ran this cell through charge and discharge cycles on a 1 J4 body. The BMS accepted the cell, reported state of charge correctly, and cutoff triggered cleanly at the low-voltage threshold without forced shutdown errors.
  • First-cycle BMS initialisation: On first install, run one full charge cycle through the camera body or OEM charger before a heavy shoot. Some 1 J4 units need that initial cycle to map the cell's discharge curve for accurate battery-remaining display.

Why the 1 J4 battery percentage reads incorrectly with a new EN-EL22 cell

The 1 J4 maps its battery indicator against a stored discharge curve calibrated to the original cell. A new cell's discharge curve doesn't align precisely until the camera BMS has logged at least one full cycle. Until then, the indicator may jump from 80% to 20% without warning. Run one complete charge-to-discharge cycle through the camera body. After that cycle, the percentage display tracks the new cell accurately.

Flash not fully recycling between shots on a new battery

The built-in flash on the 1 J4 draws a short, high-current pulse to recharge its capacitor between shots. If the cell's voltage sags under that recharge load, the flash fires before it reaches full charge, producing weaker output or slower recycle times. This often appears near the end of a cell's charge, when internal resistance rises and the voltage rail dips under load. Check cell voltage before a flash-heavy session — below 7.0V under load, recharge before shooting.

Compatibility

Check your original model and part number before ordering.

Compatible brands
NiKon
Fit Model
1 J41 S2
Part Number
EN-EL22

Specifications

Battery typeLi-ion
Voltage7.2V
Capacity850mAh
Wh6.12Wh
Dimensions50.06 x 30.39 x 12.77mm
Weight
Connector
ChemistryLi-ion

Shipping and safety

UN number:

Standard carrier options available

·

UN38.3 documentation pending

Return warning

Customer reviews

Verified purchase reviews will appear here.