About this replacement
NiKon Coolpix P7000 Series — 7.4V Li-ion Replacement Battery (EN-EL14)
This 7.4V, 1030mAh Li-ion cell replaces the OEM EN-EL14 battery in the NiKon Coolpix P7000, P7100, P7700, and P7800, along with 33 additional compatible models. It powers the camera body, LCD display, image processor, and all shooting functions. Voltage and connector match the original spec exactly.
- Coolpix P7000 series compatibility: All four P7-series bodies share the same EN-EL14 battery bay, 7.4V voltage rail, and BMS handshake protocol. A single cell covers the full lineup without adapter or modification.
- Bench tested on actual hardware: We cycled this cell through the Coolpix P7000 body and confirmed the BMS accepted the cell, reported charge state, and held voltage through sustained burst shooting without triggering an early cutoff.
- First-install charge cycle on the Coolpix P7000: Run the first full charge from inside the camera body using the OEM charger cable. Some P7000 bodies require one in-camera charge cycle before the battery-remaining indicator maps correctly to the new cell's discharge curve.
Battery percentage jumping on the P7000 display after fitting a new cell
The Coolpix P7000 maps its battery indicator to voltage thresholds calibrated for the original cell's discharge curve. A new replacement cell can show the same voltage at a different state of charge, so the indicator reads high, then drops suddenly. This is a BMS recalibration issue, not a cell fault. Run two full charge-and-discharge cycles through the camera body and the indicator will stabilise against the new curve.
P7000 showing dead battery icon on a replacement cell that just came off the charger
When a P7000 shows a dead battery icon immediately after inserting a freshly charged replacement, the camera's authentication check has not yet accepted the new cell. This happens on first insert when the BMS has no charge history for the cell. Place the battery in the OEM charger or charge in-camera until the indicator shows full, then power cycle the body. After one complete in-camera charge cycle, the body recognises the cell and the icon clears. Charge to 8.4V before the first shoot.