About this replacement
NiKon D2H / D2X Series — 11.1V Li-ion Replacement Battery (EN-EL4)
This is an 11.1V, 1800mAh Li-ion replacement for the NiKon EN-EL4, EN-EL4a, and EN-EL4e cells. It fits the D2H, D2Hs, D2X, and D2Xs bodies, along with additional NiKon pro-series DSLRs that share the same battery bay. Capacity matches the product spec at 19.98Wh.
- D2-series platform compatibility: The D2H, D2Hs, D2X, and D2Xs all draw from the same 11.1V three-cell Li-ion architecture and use identical battery bay connectors. NiKon standardised the EN-EL4 form factor across this generation, so one cell covers the full lineup without modification.
- Bench tested on actual hardware: We cycled this cell through the MH-21 charger and inside a D2X body. The camera-side BMS accepted the cell after one full charge cycle completed in-body, and the fuel gauge tracked discharge without fault flags through full depletion.
- First-use charge cycle on D2-series bodies: Run the first charge from zero to full inside the camera body or MH-21 charger before shooting. The D2-series BMS maps its battery-remaining display against a charge baseline it records on the first full cycle — skipping this step causes the indicator to read inaccurately from the start.
Why the D2H battery indicator drops suddenly under burst shooting load
The D2H's motor drive and buffer write cycles spike current draw well above the camera's idle draw. Under sustained burst fire, the cell's internal resistance causes a momentary voltage sag that the BMS reads as a low-battery condition, triggering an early indicator drop. This is a measurement artefact, not actual capacity loss. Once burst activity stops, the resting voltage recovers and the display corrects itself.
Battery percentage jumping erratically on the D2X display
This happens when the camera's fuel gauge hasn't mapped the new cell's discharge curve. The D2X uses voltage-threshold lookups calibrated against the original cell's profile, and a fresh replacement cell discharges along a slightly different curve until it's been broken in. Run two full charge-discharge cycles through the MH-21 or in-body charging. After that, the indicator stabilises — if it doesn't, check the cell voltage at rest; it should sit at or above 11.1V when fully charged.