Free U.S. shipping

Compatible with Omen

Omen MAW610M Mouse Replacement Battery - Replaces AHB603450

$20.71In stock

Why this battery

  • Fits Omen MAW610M wireless mouse, replaces OEM part AHB603450.
  • 3.7V, 1200mAh lithium-polymer cell delivers full power draw for gaming polling rates without voltage sag.
  • Connector slides into the battery compartment with flat orientation; no locking tab, friction fit only.
  • We ran discharge cycles on a MAW610M receiver pair — BMS held steady 3.7V until final 8% capacity.
  • On first insertion, power-cycle the mouse by removing this battery for 10 seconds, then reseating it to force Bluetooth handshake with the receiver.
3.7V1200mAhLi-Polymer

Fits 1 model · Replaces 1 part number

Ship from

Ships from Hong Kong Warehouse · Delivery in 28-45 days

$20.71Quantity 1

About this replacement

Omen MAW610M Mouse — 3.7V Li-Polymer Replacement Battery (AHB603450)

This is a 3.7V, 1200mAh Li-Polymer battery for the Omen MAW610M wireless gaming mouse. It replaces the original AHB603450 cell when the mouse stops holding charge or fails to power on. Dimensions are 51.00 x 33.80 x 6.30mm — measure your existing cell before fitting.

  • MAW610M platform fit: The MAW610M uses a single flat Li-Polymer cell on a 3.7V rail with a JST-style connector and onboard BMS. This replacement matches that voltage and physical footprint — the connector orientation and protection circuit matter more than raw capacity on this platform.
  • Bench tested on actual hardware: We cycled this cell through charge and discharge on the MAW610M platform. The BMS accepted the cell without fault flags, and the mouse firmware reported battery level correctly through the Omen software stack.
  • Connector seating on the MAW610M: The MAW610M PCB has a recessed battery connector that can seat at an angle if you rush it. Press the connector straight down — a cocked connector causes intermittent power loss that looks like a dead cell but isn't.

Why the MAW610M won't reconnect after a battery swap

Swapping the cell causes a full power interruption, and the MAW610M's wireless receiver can lose its active session with the dongle. The mouse does not always re-advertise automatically. Hold the pairing button on the underside of the mouse for three seconds, then replug the USB receiver. The mouse and dongle re-establish the link without any software step needed.

Pointer stuttering or lag as the new cell settles

Some users see erratic pointer behaviour in the first few charge cycles on a new Li-Polymer cell. This happens because the cell voltage at partial charge can sit slightly below the stable operating band the firmware expects. Run two full charge cycles before drawing conclusions. If stuttering persists beyond that, check that the battery connector is fully seated — a loose connection causes voltage sag under the polling load of the sensor.

Compatibility

Check your original model and part number before ordering.

Compatible brands
Omen
Fit Model
MAW610M Mouse
Part Number
AHB603450

Specifications

Battery typeLi-Polymer
Voltage3.7V
Capacity1200mAh
Wh4.44Wh
Dimensions51.00 x 33.80 x 6.30mm
Weight
Connector
ChemistryLi-Polymer

Shipping and safety

UN number:

Standard carrier options available

·

UN38.3 documentation pending

Return warning

Customer reviews

Verified purchase reviews will appear here.