About this replacement
OnePlus 7T Pro / 7T Pro 5G — 3.85V Li-Polymer Replacement Battery (BLP745)
This is a 3900mAh (15.02Wh) Li-Polymer cell replacing the original BLP745 in the OnePlus 7T Pro and 7T Pro 5G. It fits all HD1910, HD1911, HD1913, and HD1925 variants. Voltage is 3.85V nominal — identical to the factory specification.
- HD1910 / HD1911 / HD1913 / HD1925 compatibility: These four model codes share the same battery bay geometry, connector orientation, and BMS handshake protocol. The BLP745 footprint — 64.40 × 61.30 × 5.80mm — fits all four without modification to the adhesive anchor points or flex routing.
- Bench tested on actual hardware: We ran the BLP745 replacement through charge-discharge cycles on an HD1911 unit. The BMS accepted the cell without fault codes, completed a full 4.4V charge termination, and held the voltage curve within spec across the discharge sweep.
- First-cycle fast charge protocol: On first use after installation, disable Warp Charge for one complete discharge-charge cycle. The fuel gauge IC needs to map the new cell's discharge curve before high-current charging pushes accurate coulomb counting. Re-enable Warp Charge after that first full cycle.
Sudden shutdown at 20–30% on the replacement cell
This happens because the fuel gauge IC is still calibrated to the old cell's voltage-to-capacity curve. When the new cell hits its real voltage cliff — typically around 3.5V under modem or display load — the system shuts down even though the percentage readout still shows charge remaining. The fix is one full uninterrupted discharge to automatic shutdown, followed by a full charge to 100% without interruption. After that cycle, the coulomb counter resets its curve to the new cell and the percentage readout tracks accurately down to around 3.6V before the true low-voltage cutoff.
Warp Charge not activating after cell swap
The OnePlus Warp Charge protocol negotiates between the charger and the BMS on the installed cell. On a freshly installed cell, the BMS may not complete the handshake on the first plug-in, so the phone drops back to standard 5V charging. Disconnect the cable, power the phone off completely, then reconnect the official Warp Charge adapter. If the handshake still fails after a cold boot, complete one full standard charge cycle — the BMS initialisation routine typically completes during that first full charge and Warp negotiation succeeds on the next plug-in.