About this replacement
Panasonic Lumix DMC-GH3 Series — 7.4V Li-ion Replacement Battery (DMW-BLF19)
This is a 7.4V, 1600mAh Li-ion replacement battery for the Panasonic Lumix DMC-GH3 mirrorless camera system. It fits the DMC-GH3, DMC-GH3A, DMC-GH3AGK, and DMC-GH3GK, along with six additional GH3 variants. The OEM part numbers are DMW-BLF19 and DMW-BLF19E.
- GH3 series compatibility: All GH3 variants share the same battery bay geometry, 7.4V rail, and BMS handshake protocol. The DMW-BLF19 form factor and contact layout is consistent across the entire GH3 production run, including regional variants marked GK and AGK.
- Bench tested on actual hardware: We ran this cell in a GH3 body and confirmed the BMS accepted the charge cycle, reported capacity correctly on the camera display, and held voltage through sustained 1080p video recording without triggering a low-voltage cutoff.
- First-use charge cycle on the GH3: Insert this battery and run one full charge through the camera body or OEM charger before a shoot. The GH3 BMS maps its battery-remaining indicator against a charge curve it builds on first cycle — skipping this step causes the percentage readout to jump erratically from the first frame.
GH3 battery percentage jumping mid-shoot on a new cell
The GH3 uses a voltage-threshold model to estimate remaining charge. When a new cell is installed, the camera has no stored discharge curve to reference, so the percentage display can drop suddenly — often from 60% to 10% with no warning. This is not a faulty cell. The BMS is mapping voltage thresholds against a curve it has not yet calibrated. One full charge-discharge cycle from within the camera body gives the BMS enough data to display percentage accurately on subsequent use.
Flash not fully recycling between shots with a new DMW-BLF19 cell
The GH3's hot-shoe flash draws a large recharge current from the battery to rebuild the capacitor between frames. If the cell voltage sags under that burst draw, the flash fires before the capacitor is fully charged — producing underexposed frames at consistent intervals. Check battery voltage under load: a healthy DMW-BLF19 cell should hold above 7.0V during active flash cycling. If voltage is dropping below 6.8V between shots, the cell is not delivering its rated current and should be replaced or fully charged before the next shoot.