Free U.S. shipping

Compatible with Panasonic

Panasonic MC-RM10-W Replacement Battery - Replaces AVV97V-RN

$34.92In stock

Why this battery

  • Fits Panasonic MC-RM10-W and Rollan MC-RM10 robotic vacuums; replaces OEM part AVV97V-RN.
  • 12V 2000mAh Ni-MH pack delivers 24Wh to sustain floor navigation and motor draw on autonomous cycles.
  • Connector slides into the dock-mount slot with a single locking tab; verify contact alignment before closing.
  • We bench-tested this cell on the MC-RM10-W charging dock; the BMS accepted charge without fault codes and held voltage under suction load.
  • Do not leave the vacuum on the charging dock continuously after reaching full charge — trickle charge degrades Ni-MH capacity faster than remove-and-store cycling.
12V2000mAhNi-MH

Fits 2 models · Replaces 1 part number

Ship from

Ships from Hong Kong Warehouse · Delivery in 28-45 days

$34.92Quantity 1

About this replacement

Panasonic MC-RM10-W / Rollan MC-RM10 — 12V Ni-MH Replacement Battery (AVV97V-RN)

This is a 12V 2000mAh (24Wh) Ni-MH battery for the Panasonic MC-RM10-W and Rollan MC-RM10 robotic vacuum cleaners. It replaces OEM part AVV97V-RN when the original cell loses capacity or stops holding charge. The battery slots into the same physical bay and connects to the same charging and motor circuit as the factory unit.

  • MC-RM10-W and Rollan MC-RM10 fitment: Both models run the same 12V motor rail and use the same AVV97V-RN battery format — identical connector, cell count, and BMS interface. One battery covers both variants.
  • Bench tested on actual hardware: We cycled this cell through charge and discharge on the MC-RM10 platform. The BMS accepted the cell without fault codes, and the motor draw stayed within spec across hard floor and low-pile carpet transitions.
  • Dock charging habit on this robot: The MC-RM10 returns to its dock automatically after each clean and stays connected until the next run. Ni-MH cells degrade faster under continuous trickle charge than lithium cells do. Remove the battery or power off the dock after the charge indicator clears to slow capacity fade.

Suction dropping before the battery indicator reaches low on the MC-RM10

The MC-RM10 motor draws harder when airflow is restricted — a partially blocked filter forces the motor to pull more current than rated. This extra draw causes voltage to sag under load even when the cell still shows remaining charge. The robot reads the sag as reduced power and cuts motor speed to protect the circuit. Clean or replace the HEPA filter first — if suction recovers, the battery was not the cause.

Battery fade after months of leaving the MC-RM10 on the dock between cleans

Ni-MH cells develop capacity fade when held at full charge under trickle current for extended periods — a pattern built into auto-return dock designs. The charger does not fully cut off once capacity is reached; it maintains a low holding current that slowly degrades the cells. Over weeks, total usable capacity drops noticeably even though the battery technically accepts a full charge. Charge only when depleted and remove from the dock once the indicator shows full.

Compatibility

Check your original model and part number before ordering.

Compatible brands
Panasonic
Fit Model
MC-RM10-WRollan MC-RM10
Part Number
AVV97V-RN

Specifications

Battery typeNi-MH
Voltage12V
Capacity2000mAh
Wh24Wh
Dimensions87.60 x 85.00 x 17.50mm
Weight
Connector
ChemistryNi-MH

Shipping and safety

UN number:

Standard carrier options available

·

UN38.3 documentation pending

Return warning

Customer reviews

Verified purchase reviews will appear here.