About this replacement
Realme Note 60 / Note 60x — 3.91V Li-Polymer Replacement Battery (BLPB21)
This is a 3.91V, 4850mAh (18.96Wh) lithium-polymer replacement cell for the Realme Note 60 and Note 60x smartphones. It fits devices running on the RMX3933 and RMX3938 board platforms. Use this to restore a phone that no longer holds a charge or fails to power on.
- Note 60 and Note 60x platform fit: Both the RMX3933 and RMX3938 share the same battery bay dimensions, connector pinout, and BMS handshake protocol — one cell covers both variants without modification.
- Bench tested on actual hardware: We ran this cell through a full charge cycle on the RMX3933 board. The BMS accepted the handshake, charge IC ramped up normally, and the fuel gauge IC began tracking from the first discharge without throwing low-battery fault flags.
- First-cycle fast charge behaviour: On first use after installation, disable fast charging for one complete discharge-charge cycle. This allows the fuel gauge IC to recalibrate its coulomb counter against the new cell's actual discharge curve before high-current charging pushes current into an uncalibrated state.
Sudden shutdown at 20–30% on the replacement cell
This happens because the fuel gauge IC is still running the discharge curve it mapped to the old, degraded cell. When the new cell hits a voltage point the IC associates with near-empty on the old cell, it signals a shutdown — even though real capacity remains. The fix is one full uninterrupted discharge down to automatic power-off, followed by a full charge to 100% with fast charging off. After that cycle, the coulomb counter recalibrates and the reported percentage aligns with actual cell voltage.
Phone warm near the battery during the first charge after swap
A freshly installed cell has higher internal impedance than a broken-in one. The charge IC compensates by running slightly higher charge voltage, which generates more heat at the cell terminals during the first few cycles. This is normal and typically settles after two to three full cycles as impedance drops. If the phone stays consistently warm beyond the third charge cycle, check that the battery connector is fully seated — a half-latched connector increases contact resistance and keeps heat elevated.