About this replacement
Rowenta Air Force Light MS657x Series — 21.6V Li-ion Replacement Battery (FS-9100028994)
This is a 21.6V Li-ion battery pack rated at 2000mAh (43.2Wh), built to fit the Rowenta Air Force Light cordless vacuum range. It covers the MS6573, MS6573WP/BA0, and the broader MS657x series. Slot it in and the vacuum powers up on the original charger without modification.
- MS657x platform fit: Every model in this range runs the same 21.6V bus voltage, uses the same connector housing, and expects the same BMS communication profile. That shared architecture is why one cell pack covers the full MS657x lineup.
- Bench tested on actual hardware: We ran this pack through charge cycles on an MS6573 unit, confirming the BMS handshake with the Rowenta dock charger, full cell balancing across the series string, and correct low-voltage cutoff before cell damage threshold.
- Dock charging habit for this vacuum: The Air Force Light's charger does not switch to a true maintenance mode once full — it continues to push a trickle current. Remove the vacuum from the dock once the charge indicator shows full. Leaving it docked permanently compresses the usable capacity of the cells within months.
Suction dropping before the battery indicator reaches low
This happens when the motor draws more current than rated — usually because the filter is partially blocked. The BMS reads the voltage sag on the cell string as a low-battery condition and throttles power to protect the cells. The indicator hasn't moved, but current demand has spiked. Clean or replace the filter first, then recharge the pack to 21.6V before testing again.
Motor cuts out mid-clean and then recovers after a short pause
This is a BMS overcurrent trip, not a dead battery. When suction is restricted — blocked nozzle, clogged filter, or hair wrap on the brush bar — the motor load spikes beyond the BMS current limit and it opens the discharge circuit. The brief pause lets the BMS reset and the motor restarts. Clear the restriction completely, then check that the brush bar spins freely before continuing.