About this replacement
Samsung MV900F Series — 3.7V Li-ion Replacement Battery (BP88B)
This is a 3.7V, 600mAh Li-ion replacement battery for the Samsung MV900, MV900F, and EC-MV900FBPWUS compact digital cameras. It matches the BP88B form factor and slot dimensions exactly — 43.60 x 35.90 x 5.40mm. Fit the cell and the camera powers on without hardware modification.
- MV900 and MV900F compatibility: Both camera variants use the same BP88B battery bay, voltage rail, and BMS handshake protocol. One cell covers the full MV900 line.
- Bench tested on actual hardware: We cycled this cell through the Samsung OEM charger and via in-body charging. The BMS accepted the cell, balanced charge termination fired correctly at 4.2V, and the battery-remaining indicator tracked accurately across discharge.
- First-use charge cycle on the MV900: Run the first full charge through the camera body or OEM charger before shooting. The MV900 BMS maps its battery-percentage display to a discharge curve it calibrates on that first charge cycle — skipping it can cause the indicator to jump erratically mid-shoot.
Flash capacitor recharge sagging on the BP88B near end of charge
The MV900F flash circuit pulls a short burst of high current to recharge its capacitor between shots. Near the bottom of the cell's discharge curve — typically below 3.5V — that current draw causes a momentary voltage sag. The camera interprets the sag as a critically low cell and either delays the ready signal or shows a low-battery warning even with charge remaining. This is a BMS threshold response, not a cell fault. Keep the cell above 30% charge during flash-heavy shooting to avoid it.
Battery percentage jumping erratically after fitting the replacement cell
The MV900's fuel gauge maps percentage to voltage thresholds calibrated against the original cell's discharge curve. A new cell with a slightly different internal resistance reads differently at each threshold point, causing the display to skip steps or jump backwards. This is not a faulty cell — it corrects itself after one full charge and discharge cycle. Charge to 100% via the OEM charger, shoot until the camera shuts off on its own, then recharge fully and the indicator will track normally.