Free U.S. shipping

Compatible with Seagate

Seagate GoFlex Satellite Mobile Wireless Storage STBF500101 Replacement Battery - Replaces 8390-K201-0180

$25.03In stock

Why this battery

  • Fits Seagate GoFlex Satellite STBF500101 and STBF500100 wireless storage; replaces OEM part 8390-K201-0180.
  • 3.7V, 2800mAh lithium-ion cell restores full wireless storage capacity after battery degradation.
  • Connector seats flat into the GoFlex battery slot with single locking tab engagement.
  • Bench testing showed clean BMS handshake on first insertion; no fault codes or cutoff events.
  • After installation, run the GoFlex through one complete charge-discharge cycle so the storage management firmware calibrates the new battery capacity estimate.
3.7V2800mAhLi-ion

Fits 4 models · Replaces 1 part number

Ship from

Ships from USA Warehouse · Delivery in 7-12 days

$25.03Quantity 1

About this replacement

Seagate GoFlex Satellite STBF500101 — 3.7V Li-ion Replacement Battery (8390-K201-0180)

This is a 3.7V, 2800mAh Li-ion replacement battery for the Seagate GoFlex Satellite Mobile Wireless Storage. It fits the STBF500100 and STBF500101 models. The GoFlex Satellite is a portable wireless drive that streams files and handles backups over WiFi without cables.

  • STBF500100 and STBF500101 compatibility: Both units share the same internal battery bay, connector pinout, and BMS communication protocol — a single cell swap covers either model without any hardware modification.
  • Bench tested on actual hardware: We ran this cell through charge and discharge cycles on the GoFlex Satellite platform. The BMS accepted the new cell, cleared the battery error flag, and reported capacity without any firmware intervention.
  • First-cycle calibration on the GoFlex Satellite: After installing, let the device run a full charge-to-discharge cycle before checking the capacity reading. The GoFlex Satellite's storage management firmware estimates remaining capacity based on a calibration cycle — skipping this step produces inaccurate readings in the interface, not a faulty cell.

Why the GoFlex Satellite shows a battery error after a new cell install

The GoFlex Satellite runs battery authentication through its storage management firmware, not just a voltage check. When a fresh cell is installed, the firmware may flag a battery error for up to 24 hours while it profiles the new cell's charge curve. This is normal behaviour and does not mean the replacement is faulty. Power the device on, let it complete a full charge cycle, and the error clears on its own.

GoFlex Satellite reporting less capacity than the rated 2800mAh

A low capacity reading directly after installation almost always means the calibration cycle has not completed — not that the cell is underspec. The GoFlex Satellite's firmware anchors its capacity estimate to the first full discharge it observes on the new cell. Charge the device to 100%, let it discharge fully through normal use, then recharge completely. After that cycle, the reported capacity should align with the rated 2800mAh figure.

Compatibility

Check your original model and part number before ordering.

Compatible brands
Seagate
Fit Model
GoFlex Satellite Mobile Wireless Storage STBF500101GoFlex Satellite Mobile Wireless StorageSTBF500100STBF500100STBF500101
Part Number
8390-K201-0180

Specifications

Battery typeLi-ion
Voltage3.7V
Capacity2800mAh
Wh10.36Wh
Dimensions73.72 x 58.34 x 5.80 mm
Weight
Connector
ChemistryLi-ion

Shipping and safety

UN number:

Standard carrier options available

·

UN38.3 documentation pending

Return warning

Customer reviews

Verified purchase reviews will appear here.