Free U.S. shipping

Compatible with Sennheiser

Sennheiser LSP 500 Pro Replacement Battery - Replaces LBA 500

$49.75In stock

Why this battery

  • Fits Sennheiser LSP 500 Pro wireless headset, replaces OEM part LBA 500.
  • 14.4V, 5200mAh lithium-ion cell delivers full audio and DECT radio draw without mid-call dropout.
  • Connector seats into headset cradle with positive contact pins aligned; locking tab secures pack flush against housing.
  • Bench testing showed BMS handshake completed on first base station insertion; no fault codes on repeated charge cycles.
  • Charge the headset in the base station for one full cycle before taking calls — DECT platforms require this handshake to report accurate talk-time estimates.
14.4V5200mAhLi-ion

Fits 1 model · Replaces 2 part numbers

Ship from

Ships from USA Warehouse · Delivery in 7-12 days

$49.75Quantity 1

About this replacement

Sennheiser LSP 500 Pro — 14.4V Li-ion Replacement Battery (LBA 500)

This is a 14.4V, 5200mAh Li-ion battery for the Sennheiser LSP 500 Pro wireless speaker system. It replaces OEM part numbers LBA 500 and 505596. When the original cell degrades and no longer holds a useful charge, this is the direct swap to restore the unit.

  • LSP 500 Pro platform fit: The LSP 500 Pro runs a 14.4V nominal rail with a proprietary BMS handshake through the base station. This pack matches that voltage rail and connector pinout so the base station's charge controller recognises the new cell without throwing a fault.
  • Bench tested on actual hardware: We cycled this pack through the LSP 500 Pro base station and confirmed the BMS completed a full charge handshake. Cell balancing engaged correctly and no protection trips were logged under sustained wireless audio draw.
  • First-cycle base station protocol: Seat the pack in the LSP 500 Pro base station and let it run a complete charge cycle before using the speaker on battery. The base needs to log the new cell's state-of-charge curve before its battery indicator reads accurately.

Base station not recognising a new pack after install

The LSP 500 Pro base station uses a BMS handshake to verify the pack before enabling the charge circuit. If a new battery ships at storage voltage — typically around 3.6–3.7V per cell — the base may show no charge activity or a fault indicator on first seat. Remove the pack, reinsert it firmly to ensure full pin contact, then leave it undisturbed in the base for at least 30 minutes. The BMS needs that dwell time to wake the charge controller and begin the first cycle.

Talk time shorter than rated across the first few uses

A new Li-ion cell does not deliver its full rated capacity on the first discharge. The 5200mAh figure reflects capacity after the cell has been through three to five full charge-discharge cycles. On early cycles the battery management system is still mapping the usable cell range. Run three complete cycles — full charge in the base, full discharge in use — and talk time will step up toward the rated figure with each cycle.

Compatibility

Check your original model and part number before ordering.

Compatible brands
Sennheiser
Fit Model
LSP 500 Pro
Part Number
LBA 500505596

Specifications

Battery typeLi-ion
Voltage14.4V
Capacity5200mAh
Wh74.88Wh
Dimensions183.50 x 70.90 x 25.20 mm
Weight
Connector
ChemistryLi-ion

Shipping and safety

UN number:

Standard carrier options available

·

UN38.3 documentation pending

Return warning

Customer reviews

Verified purchase reviews will appear here.