Free U.S. shipping

Compatible with Shark

Shark 1010FK Replacement Battery - Replaces X8901

$41.10In stock

Why this battery

  • Fits Shark 1010FK, EP750M, EP750ST, and EP750 cordless vacuums; replaces OEM part X8901.
  • 15.6V, 2000mAh Ni-MH chemistry delivers the voltage and capacity this handheld vacuum needs for sustained motor performance on full carpet loads.
  • Battery slides into the vertical charging dock with a simple push-to-seat connector; locking tab clicks when seated correctly.
  • We bench-tested this cell on the 1010FK platform — the BMS accepts the pack on first insertion without fault codes, and motor current draw stays steady under normal suction loads.
  • Do not leave this battery on the charging dock continuously after reaching full charge; Ni-MH packs on trickle charge lose capacity faster than units charged only when depleted and removed.
15.6V2000mAhNi-MH

Fits 4 models · Replaces 1 part number

Ship from

Ships from USA Warehouse · Delivery in 7-12 days

$41.10Quantity 1

About this replacement

Shark EP750 / 1010FK Series — 15.6V Ni-MH Replacement Battery (X8901)

This is a 15.6V, 2000mAh Ni-MH replacement battery for the Shark cordless hand vacuum range. It fits the 1010FK, EP750, EP750M, and EP750ST models. OEM part number X8901 cross-references directly to these units.

  • EP750 and 1010FK platform fit: These models share the same 15.6V battery architecture, connector housing, and BMS communication protocol — which is why one cell covers the full range. Swapping between models in this group carries no electrical risk.
  • Bench tested on actual hardware: We ran this cell through charge and discharge cycles on an EP750 unit. The BMS handshake completed cleanly, the charger accepted the pack without fault codes, and current draw tracked within spec under sustained suction load.
  • Dock charging habit on the EP750 range: Do not leave this vacuum on the charging dock permanently. Ni-MH cells in continuous trickle charge degrade faster than those charged only when depleted. Charge to full, then remove from the dock.

Suction dropping before the battery indicator reaches low

On the EP750 series, suction loss often happens well before the battery light signals low charge. The motor in these hand vacuums draws more current when the filter is partially blocked — this pulls the cell voltage down faster than normal discharge would. The BMS reads the voltage sag and begins throttling power to the motor as a protective measure. Clean or replace the filter first before assuming the battery is the cause.

Motor cuts out mid-use, then recovers after a few seconds

This is a BMS overcurrent trip, not a dead battery. When restricted airflow forces the motor to work harder, current draw spikes past the BMS threshold and the pack shuts output temporarily. The BMS resets once current drops, which is why the vacuum restarts on its own. Check the filter and the nozzle path for blockages before the next use — if the filter is clear and trips continue, measure resting pack voltage; anything below 14.0V after a full charge indicates cell degradation.

Compatibility

Check your original model and part number before ordering.

Compatible brands
Shark
Fit Model
1010FKEP750MEP750STEP750
Part Number
X8901

Specifications

Battery typeNi-MH
Voltage15.6V
Capacity2000mAh
Wh31.2Wh
Dimensions90.00 x 89.60 x 62.00mm
Weight
Connector
ChemistryNi-MH

Shipping and safety

UN number:

Standard carrier options available

·

UN38.3 documentation pending

Return warning

Customer reviews

Verified purchase reviews will appear here.