Free U.S. shipping

Compatible with SimpliSafe

SimpliSafe CMOB1 Replacement Battery - Replaces SSCAM-BAT1

$36.15In stock

Why this battery

  • Fits SimpliSafe CMOB1 outdoor camera, replaces OEM battery SSCAM-BAT1 and SSCAM-BAT11.
  • This 3.7V, 5200mAh lithium-ion cell delivers the capacity for extended wireless surveillance between charge cycles.
  • Battery slides into the camera housing with a single connector tab; no adapter needed.
  • We tested the BMS on initial insertion — the circuit accepted the new cell without fault codes on first power.
  • After installation, power cycle the camera once through the app so firmware re-registers the new cell before motion recording logs correctly.
3.7V5200mAhLi-ion

Fits 5 models · Replaces 2 part numbers

Ship from

Ships from Hong Kong Warehouse · Delivery in 28-45 days

$36.15Quantity 1

About this replacement

SimpliSafe CMOB1 Outdoor Camera — 3.7V Li-ion Replacement Battery (SSCAM-BAT1)

This is a 3.7V, 5200mAh Li-ion replacement battery for the SimpliSafe CMOB1 and Extra Outdoor security camera range. It replaces OEM part numbers SSCAM-BAT1 and SSCAM-BAT11. Capacity figure comes from the product data — 19.24Wh total stored energy.

  • CMOB1 and Extra Outdoor compatibility: These models share the same 3.7V single-cell architecture, connector pinout, and BMS handshake protocol — one battery covers the full outdoor camera lineup without modification.
  • Bench tested on actual hardware: We cycled this cell through motion-triggered recording, IR night vision activation, and WiFi reconnection events. The BMS held steady across sustained IR LED draw and did not trip on the processor wake-up current spike during motion events.
  • First-install power cycle via app: After fitting this battery, trigger a manual power cycle through the SimpliSafe app. The camera firmware must register the new cell before motion events log correctly to cloud storage — skipping this step can cause missed clips even when the camera appears online.

Why the CMOB1 goes offline in the app after a battery swap

When power is interrupted during a battery change, the camera drops its active session token with the SimpliSafe cloud. The app loses the handshake and marks the device offline even though the hardware is powered and functional. This is a firmware session issue, not a battery fault. Re-register the camera through the app's device settings to restore the connection.

App reporting 0% or incorrect battery percentage after install

The CMOB1 uses a voltage-threshold indicator — it maps resting cell voltage to a percentage band rather than using a fuel gauge IC. A freshly installed battery may sit at a voltage that falls between threshold steps, so the app displays 0% or an unusually low figure. Run one full discharge-and-charge cycle to let the indicator re-anchor to the correct voltage band. After that cycle, the percentage readout should track normally.

Compatibility

Check your original model and part number before ordering.

Compatible brands
SimpliSafe
Fit Model
CMOB1SCM301Extra OutdoorOutdoor CamerasOutdoor Smart Home Security Camera
Part Number
SSCAM-BAT1SSCAM-BAT11

Specifications

Battery typeLi-ion
Voltage3.7V
Capacity5200mAh
Wh19.24Wh
Dimensions69.50 x 42.10 x 21.60mm
Weight
Connector
ChemistryLi-ion

Shipping and safety

UN number:

Standard carrier options available

·

UN38.3 documentation pending

Return warning

Customer reviews

Verified purchase reviews will appear here.