Free U.S. shipping

Compatible with SkyBell

SkyBell Slim Line Mounting Bracket Replacement Battery - Replaces PH422536P

$20.09In stock

Why this battery

  • Fits SkyBell Slim Line Mounting Bracket doorbells; replaces OEM part PH422536P.
  • 3.7V, 320mAh lithium-polymer cell powers video, audio, and motion detection continuously.
  • Connector slides into vertical slot with locking tab; verify orientation before seating.
  • Bench test showed stable 3.7V output under IR LED and WiFi burst loads.
  • On first boot, power cycle the doorbell once through the SkyBell app — firmware must register the new cell before motion recording logs correctly to cloud.
3.7V320mAhLi-Polymer

Fits 3 models · Replaces 1 part number

Ship from

Ships from USA Warehouse · Delivery in 7-12 days

$20.09Quantity 1

About this replacement

SkyBell Slim Line / Trim Plus / SBHD10 — 3.7V Li-Polymer Replacement Battery (PH422536P)

This 3.7V, 320mAh lithium-polymer cell replaces OEM part PH422536P in SkyBell Slim Line, Trim Plus, and SBHD10 video doorbells. It powers the camera, motion sensor, two-way audio, and Wi-Fi radio. Physical dimensions are 37.50 × 25.00 × 4.00mm — confirm these against your existing cell before installing.

  • Slim Line, Trim Plus, and SBHD10 compatibility: All three models share the same battery bay geometry, connector pinout, and 3.7V voltage rail. The BMS handshake is identical across this bracket family, so one cell fits all three without modification.
  • Bench tested on actual hardware: We cycled this cell through SkyBell's combined IR-LED and Wi-Fi radio draw. The BMS held stable through motion-trigger current spikes and did not false-trip during back-to-back recording events.
  • First-install power cycle requirement: After fitting the new cell, power cycle the doorbell once through the SkyBell app. The firmware must re-register the cell before motion events log correctly to cloud storage — skipping this step causes missed clips on early triggers.

Why the SBHD10 drops offline in the app after a battery swap

Swapping the cell clears the doorbell's active session token. The unit reconnects to Wi-Fi but the SkyBell app does not automatically re-authenticate the device. This shows as "offline" or "unavailable" in the app even though the camera's LED may appear active. Open the app, navigate to device settings, and force a reconnect — the doorbell re-registers and resumes live view within about 30 seconds.

App showing 0% or a frozen charge percentage after install

SkyBell's charge indicator reads voltage thresholds, not a fuel-gauge IC. A new cell sitting near full charge can read 0% or display the previous cell's last-known value until the firmware calibrates. Run one full charge cycle through the mounting bracket's charge contacts — once the cell reaches 4.2V and the charger cuts off, the indicator resets and tracks accurately from that point forward.

Compatibility

Check your original model and part number before ordering.

Compatible brands
SkyBell
Fit Model
Slim Line Mounting BracketTrim PlusSBHD10
Part Number
PH422536P

Specifications

Battery typeLi-Polymer
Voltage3.7V
Capacity320mAh
Wh1.18Wh
Dimensions37.50 x 25.00 x 4.00mm
Weight
Connector
ChemistryLi-Polymer

Shipping and safety

UN number:

Standard carrier options available

·

UN38.3 documentation pending

Return warning

Customer reviews

Verified purchase reviews will appear here.