About this replacement
SonoScape Portable Ultrasound — 14.4V Li-ion Replacement Battery (KL42-067HY0)
This is a 14.4V, 6500mAh (93.6Wh) lithium-ion replacement battery for SonoScape portable ultrasound systems. It replaces OEM part number KL42-067HY0. The battery maintains the voltage and capacity the system's BMS expects to complete startup and support continuous scanning sessions in clinical environments.
- SonoScape portable ultrasound platform: SonoScape portable units draw consistent, moderate current during active imaging. The BMS on these systems monitors cell voltage tightly to protect probe circuitry and internal processing boards from supply fluctuation. This battery matches the 14.4V nominal rail and cell configuration the original firmware expects.
- Bench tested on actual hardware: We cycled this battery through charge and full-load discharge on ultrasound-class equipment. The BMS handshake completed without fault codes, and the protection circuit responded correctly to both peak imaging loads and standby draw transitions.
- Post-swap self-test protocol: After installing this battery, let the SonoScape unit complete its full power-on self-test without interruption. Medical imaging systems run a BMS verification sequence at boot — cutting power during this window triggers a battery fault flag that persists until the next clean reboot cycle.
Why SonoScape units flag a battery fault after the first installation
SonoScape portable systems apply a conservative BMS learn algorithm on first use. Fresh lithium cells have a slightly different internal resistance profile than a broken-in cell, and the charge IC may interpret this as a chemistry mismatch. The device may display a battery warning or limit charge acceptance on the first cycle. Running one complete charge-to-full, then a full imaging-load discharge, allows the BMS to calibrate its state-of-charge model to the new cell. After that first cycle, the fault flag clears and charge reporting normalises.
Charge indicator stuck below 100% on the first charge
On first charge, the SonoScape charge IC applies a reduced top-off current to new cells as a safety measure. This causes the on-screen charge percentage to plateau — typically between 85% and 95% — before the session ends. The cell is not defective; the charge controller is deliberately holding back until it confirms cell stability at the upper voltage limit. Allow the unit to remain on charge for a full uninterrupted session. After the first full charge cycle, the IC releases the current limit and subsequent charges should reach 100% and report accurately.