About this replacement
Tribit Stormbox / XSound Plus 2 — 7.4V Li-ion Replacement Battery (INR18650-2S1P)
This is a 7.4V, 2600mAh (19.24Wh) Li-ion replacement battery for the Tribit Stormbox Bluetooth Speaker and the XSound Plus 2 Bluetooth Speaker. It slots into the same position as the original INR18650-2S1P cell pack. When the original degrades, audio cuts out early or the speaker stops holding a charge entirely — this restores cordless playback.
- Stormbox and XSound Plus 2 compatibility: Both models share the same 7.4V two-cell series configuration and identical connector pinout. The BMS handshake on each speaker accepts the same charge termination voltage, so one cell pack covers both platforms without modification.
- Bench tested on actual hardware: We ran this pack through charge and discharge cycles on a Stormbox unit. The BMS held charge termination at 8.4V and triggered low-voltage cutoff cleanly at 6.0V, with no false cutoff during high-volume amplifier draw spikes.
- Fuel gauge calibration after install: After fitting this battery, run the speaker to below 20% charge before topping it back to full — at least once a month. Constant top-off charging without a full discharge causes fuel gauge drift, and the speaker's indicator will begin misreporting remaining capacity within a few weeks.
Amplifier current spikes and voltage sag at high volume
At high playback volume, the Stormbox's Class D amplifier pulls sharp current spikes that can momentarily drag cell voltage below the BMS protection threshold. A degraded original battery has higher internal resistance, which makes sag worse and can trigger cutoff mid-track. This replacement pack uses fresh 18650 cells with lower internal resistance, which reduces sag under those transient loads. The result is cleaner voltage delivery across the full volume range.
Speaker won't wake from USB-C charging after full discharge
If the Stormbox sits unused long enough for the cells to drop below roughly 5.5V, the USB-C controller won't accept a standard charge handshake — the port appears dead. Most chargers require the cell pack to be at or above the USB PD minimum acceptance threshold before negotiation starts. Use a charger that supports trickle or pre-charge mode, connect it, and leave the speaker untouched for 20–30 minutes before attempting to power on. Once cells recover above 6.0V, normal charging resumes.