About this replacement
VeriFone V240m Plus — 3.7V Li-ion Replacement Battery (BPK474-001)
This 3.7V, 2600mAh Li-ion battery replaces the original BPK474-001 cell in the VeriFone V240m Plus payment terminal. It also fits the V240m, V240m 3G, and V240m 3GBWC variants that share the same battery bay and connector. Voltage and capacity match OEM spec exactly.
- V240m family compatibility: The V240m, V240m Plus, V240m 3G, and V240m 3GBWC all use the same 3.7V battery bay, physical connector, and BMS handshake protocol — that is why one cell covers the entire family.
- Bench tested on actual hardware: We ran this cell through a full boot sequence on a V240m Plus unit. The BMS accepted the handshake on first power-up, the terminal completed its PCI security boot, and the charge indicator reported correctly within one full charge cycle.
- First deployment tip: After fitting this battery, run the terminal through at least one complete transaction cycle before putting it into live service. The V240m maps battery capacity during normal operation — skipping this step leaves the charge indicator uncalibrated and can trigger a low-battery warning mid-shift despite a full cell.
Terminal not completing PCI boot sequence after a battery swap
The V240m Plus runs a PCI security check during every boot, and that check pulls a brief current spike as it initialises the wireless and tamper-detection circuits. On a brand-new cell, the BMS has not yet established a charge baseline, so it can interpret that spike as an out-of-range draw and stall the boot. Plugging the terminal into the charging cradle before the first boot gives the BMS time to register the cell and set a baseline. One full charge-to-discharge cycle resolves this in almost every case.
Terminal rebooting mid-transaction when printing a receipt
The receipt printer motor in the V240m draws a sharp current spike the moment it fires — far higher than the idle display or wireless draw. If the battery cell voltage is already sagging from a partial charge or a degraded cell, that spike can pull voltage below the BMS cutoff threshold, triggering an instant shutdown and reboot. This is not a terminal fault. Charge the battery fully before the shift and confirm the terminal reads above 3.9V under the settings menu before going live.