About this replacement
Vivo V21e Series — 3.87V Li-Polymer Replacement Battery (B-Q6)
This is a 3.87V, 3900mAh Li-Polymer replacement battery for the Vivo V21e, V21e 5G, and V2055 smartphones. Part number B-Q6 matches the OEM specification for these models. It restores power to a device that no longer holds charge or shuts down unexpectedly.
- V21e, V21e 5G, and V2055 compatibility: These three models share the same battery bay geometry, connector pinout, and BMS handshake protocol. The B-Q6 cell works across all three without modification — the fuel gauge IC on each recognises the same charge curve.
- Bench tested on actual hardware: We cycled this cell through full charge and discharge on a V21e unit. The BMS accepted the cell without rejection flags, and the charge IC transitioned correctly from CC to CV phase at 4.40V cutoff.
- Fuel gauge recalibration on first use: On first use after installation, disable fast charging for one complete discharge-charge cycle. This lets the fuel gauge IC recalibrate against the new cell's discharge curve before high-current charging pushes current into an uncalibrated cell.
Why the V21e reports wrong battery percentage after a cell swap
The V21e uses a coulomb-counter fuel gauge IC that stores the discharge curve of the original cell in memory. When a new cell goes in, that stored curve no longer matches the actual cell chemistry. The gauge reads the wrong state of charge because it is still calculating against old data. One full discharge to 5% and a complete charge to 100% with fast charging off forces the IC to relearn the new cell's curve and restore accurate percentage reporting.
Sudden shutdown at 20–30% charge remaining on the replacement cell
This is a voltage cliff issue, not a capacity problem. When the modem, display, or a background process draws a high current, the cell voltage briefly drops below the BMS cutoff threshold — even though the reported percentage looks safe. On a new, uncalibrated cell this happens more often because the fuel gauge IC overestimates remaining charge. Run one full calibration cycle first. If shutdowns continue after calibration, check that the battery connector is fully seated, as a loose pin increases contact resistance and worsens voltage sag under load.