About this replacement
Xiaomi Mi 8 Youth — 3.85V Li-Polymer Replacement Battery (BM3J)
This is a 3250mAh Li-Polymer cell at 3.85V, replacing part number BM3J in the Xiaomi Mi 8 Youth, Mi 8 Youth Standard Edition, Mi 8 Youth Standard Edition Dual SIM, and M1808D2TE. It fits when the original cell has degraded, swells, or no longer holds a usable charge. Voltage and capacity match the stock specification exactly.
- Mi 8 Youth platform fit: The Mi 8 Youth, its Standard Edition, Dual SIM variant, and M1808D2TE all share the same battery bay geometry, connector pinout, and BM3J BMS handshake — the PMIC on this board checks cell identification on boot, so the part number must match to unlock fast charge signalling.
- Bench tested on actual hardware: We seated this cell in an Mi 8 Youth, ran the device through a full boot sequence, and confirmed the BMS negotiated correctly with MIUI's charge IC. Capacity readout at first boot landed within 2% of rated spec under a controlled load.
- First-cycle fuel gauge recalibration: On first use after installation, disable fast charging and run one complete discharge-to-charge cycle. The fuel gauge IC was calibrated against the old cell's discharge curve — giving it one uninterrupted reference cycle before high-current charging prevents it from locking onto a skewed coulomb counter baseline.
Sudden shutdown at 20–30% on the Mi 8 Youth after a cell swap
This happens because the fuel gauge IC still holds the discharge curve of the old, degraded cell. The new cell has a steeper voltage cliff at low state-of-charge — the PMIC sees the rail drop below the cutoff threshold under modem or display load before the reported percentage reaches zero. The phone interprets this as a hard undervoltage event and shuts down to protect the system, even though the displayed percentage suggests charge remains. Running two full discharge-charge cycles without fast charging lets the coulomb counter re-anchor to the new cell's actual curve and eliminates most false shutdowns.
USB-PD or MIUI fast charge not activating after replacement
After a cell swap, some Mi 8 Youth units revert to standard 5V/1A charging on the first cycle — the charge IC runs a handshake protocol on power-up that checks BMS response time, and a brand-new cell at partial state-of-charge can respond outside the expected window. This is not a fault with the charger or the cable. Fully discharge the phone to automatic shutdown, then connect the original fast charger from a cold boot. On the second or third full cycle, fast charge negotiation typically resumes at the correct voltage step.